Gaiter for heat-shrinkable tubings for cables 30-10 mms (earth installation)

Item number
4017
Content
1 piece

11,70 (Unit price: 11,70 € / piece)

incl. 19 % VAT. excl. shipping


within 24 - 48 hours



Repairing Gaiter for heat shrinking tubes 250 mms for cables of 30-10 mms

e.g. for water-proof protection of connections in case of installation in the ground.

Before shrinking 36mms / After shrinking 10mms / Polyolefin with middle wall

Half-rigid, middle-walled polyolefin with thermoplastic glue.

Due to its good chemical and electric characteristics, this product is suitable for quick and water-proof repairing also of outdoor cables. Good UV resistance as well as good resistance against cold flow allow safe repairing of damages in jackets of cables and wires isolated by plastics. Good resistance against alkaline earths allows installation in the ground.  

• half-rigid and including middle wall
• with thermoplastic glue
• not self-extinguishing
• Polyolefin

Shrinking ratio: 3,5:1 ( 70%)
Operating temperature: -40°C up to +125°C
Processing temperature: 130°C
Puncture strength: 19,7kV/mm

Deliverd sizes: length of each piece 250mms + 1x cleaning cloth, 1x abrasive paper

Processing advice

Only a few working steps are necessary for a correct completion of the repair. The processing is supposably easy.
Clean the damaged part of the cable from dirt, moisture, grease etc. and clean it thoroughly with the supplied cleaning cloth.
Roughen the part which is to be repaired with the enclosed abrasive paper. Remove the protection foil and pull the gaiter around the cabel and
mount the stainless steel bar. Then start shrinking from the middle with rotary movements.
Warmth should be applied until the glue leaks out at both ends. After cooling down for ca. 15 minutes the connection can be mechanically stressed.

e.g. for water-proof protection of connections in case of installation in the ground
Before shrinking 36mms / After shrinking 10mms / Polyolefin with middle wall; Half-rigid, middle-walled polyolefin with thermoplastic glue.
Due to its good chemical and electric characteristics, this product is suitable for quick and water-proof repairing also of outdoor cables. Good UV resistance as well as good resistance against cold flow
allow safe repairing of damages in jackets of cables and wires isolated by plastics. Good resistance against alkaline earths allows installation in the ground. 
half-rigid and including middle wall - with thermoplastic glue - not self-extinguishing - Deliverd sizes: length of each piece 250mms + 1x cleaning cloth, 1x abrasive paper

– No feedback has been given for Gaiter for heat-shrinkable tubings for cables 30-10 mms (earth installation). –
Up